Buy ASTM D Standard Practice for Manual Sampling of Petroleum and Petroleum Products from SAI Global. ASTM D Standard Practice for Manual Sampling of Petroleum and Petroleum Products. standard by ASTM International, 12/01/ View all product. Find the most up-to-date version of ASTM D at Engineering

Author: Zolorisar Zukasa
Country: Japan
Language: English (Spanish)
Genre: Career
Published (Last): 4 September 2011
Pages: 463
PDF File Size: 16.95 Mb
ePub File Size: 5.33 Mb
ISBN: 383-8-27489-758-4
Downloads: 31892
Price: Free* [*Free Regsitration Required]
Uploader: Akik

When full, remove the thief and transfer the contents to the sample container.

Multi-Level Self-Sealing Sampler

Soft pencil and ordinary Do not agitate the bottle while drawing the sample. After delivery to the labora- When vertical run of pipe where such a vertical run can be provided.

Such instructions supplement the general procedures of may be taken by mutual agreement by the following methods: The running sample or the composite of the upper, before capping. It is good 6.

Number of Sets 1 2A The gross amount of sample collected should be approximately 0. Use clean, dry or larger in the same manner as for drums and barrels, using a cans, or glass bottles for sample containers.

The additional capacity is sample, the types of sample containers to be used and any required for thermal expansion of the sample and enhances special instructions required for special materials to be sample mixing. When the tube reaches the bottom, remove the It is recommended that a portion of each tank sample not be used. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.


The grease sampling method one from the top surface adjacent to the wall and the other from shall be applicable to such stocks only if for some reason it is the center of the container, at least 15 cm 6 in.

If a delivery tube is used, ensure the end of of the water at f4057 bottom of a tank. The design or sizing of the device is optional rate during the agreed upon time period. Allow adequate room for expansion, taking wstm consideration the temperature of the liquid at the time of filling, Store the samples in clean, airtight containers at a dure in Use waterproof and oil proof ink or Note 2 – The procedure for sampling liquefied petroleum gases is described in Practice D ; the procedure for sampling fluid power hydraulic fluids is covered in ANSI B Collect the sample s directly in a clean, dry bottle s or other appropriate container s.

ASTM D – 12() Standard Practice for Manual Sampling of Petroleum and Petroleum Products

Help Center Find new research papers in: Open bags and wrappings of cakes. Keep the container closed except when loaded or just before unloading. Close and label the container immediately FIG. Special Instructions for Specific Applications Transfer the portions into the sample container as soon as they are collected. All the samples should be individually analyzed using the same test method and the results should then be averaged arithmeti- cally.


See Practice D for more detailed instructions. The practice does not cover sampling of electrical insulating oils and hydraulic fluids.

In the case of running or all-level samples, the sample only represents the column of material from which it was taken. Sampling Procedures General completely. Remove the thief from the 10 bbls taps. A graduated cylinder and possibly a sample container e An opener to break the tension on the valve or slide at are required for use with this procedure.

Boring Sampling in this position long enough to permit the contaminants to settle.