The Cisco ASR X Router offers embedded services for enterprise and service provider networks in a 2-rack unit (2RU) small form factor. It is integrated with. ASR X Router: Access product specifications, documents, downloads, Visio stencils, product images, and community content. Data sheet describes how the Cisco SPA/SIP portfolio offers a rich set of QoS features for premium service delivery.

Author: Aranos Tutaxe
Country: Benin
Language: English (Spanish)
Genre: Literature
Published (Last): 28 March 2012
Pages: 227
PDF File Size: 18.26 Mb
ePub File Size: 14.3 Mb
ISBN: 771-7-84906-548-2
Downloads: 22327
Price: Free* [*Free Regsitration Required]
Uploader: Gogrel

Cisco ASR Series Aggregation Services Routers Overview

A tunnel interface is configured to be the logical interface associated with the tunnel. SA Lifetime – set the lifetime of the security associations after which a reconnection will occur. To get started with the Cisco ASR Series, refer to the detailed product part numbers and descriptions in the following tables: The Cisco ASR only sips power and takes up little rack space, thanks to the fact that the router has been designed in as a compact qsr factor device.

A two-rack unit, the Cisco ASR is a router that has datashdet serial interface processors and an integrated route.

Cisco ASR Router Datasheet and Installation

Check Best practices for further recommendations on peer configurations. Dynamic Routing router bgp bgp log-neighbor-changes neighbor Allowed protocols and ports: You must enter the same shared secret into both VPN gateways. An IKEv2 policy with no proposal is considered incomplete. Saving the configuration To dattasheet the running configuration and set it as the default startup, run the following command on Cisco IOS terminal: To define the route priority run the below command.


This information is provided as an example only.

Association with the IPsec security association is done through the tunnel protection command. The following example sets IKE version to 2. Set to seconds as recommended configuration on ASR router. Many aftermarket retail sellers, however, still sell the device, whether used or new. If an entire virtual device fails, Cloud VPN automatically instantiates a new one with the same configuration, so you don’t need to build two Cloud VPN gateways. Go to the Firewall rules page. Previous post Next post.

Cisco ASR 1000 ASR1000-RP1= Data Sheet

Back to home page. Logos remain the property of the corresponding company. The Cisco ASR Series Routers carry a modular yet integrated design, so network operators can increase their network capacity and services without a hardware upgrade.

If a Cloud VPN tunnel goes down, it restarts automatically. Make a note of the created address for use in future steps. The topology outlined by this guide is a basic site-to-site IPsec Ase tunnel configuration using the referenced device:.

The upcoming section provide details to both in detail below:. The range, or ranges, of the peer network, which is the network on the other side of the tunnel from the Cloud VPN gateway you are currently configuring.

Actually, you may be strange to the ASR Series because these routers always work for a carrier or service provider or a very large enterprise. During tunnel establishment, the two peers negotiate security associations that govern authentication, encryption, encapsulation, and key management.

How many rack units RUs do you need? Except as otherwise noted, the content of this page is licensed under the Creative Commons Attribution 4. This name is displayed in the console and used by the gcloud command-line tool to reference the gateway.


This name is displayed in the console and used by the gcloud command-line tool to reference the router. You can repeat this command to add multiple ranges to the VPN tunnel. The default, and preferred, IKE version is 2. Service provider, enterprise network edge, xsr.

If you are using static routing then instead of BGP configurations mentioned above, you can change the metric higher the metric lower the preference for your static route as shown below:. All traffic routed to the tunnel interface will be encrypted and transmitted to the GCP.

Any references to IP addresses, device IDs, shared secrets or keys account information or project names should be replaced with the appropriate values for your environment when following this guide.

They comprise the memory, hard disk, and USB flash memory token.

Set to 36, seconds as recommended configuration on ASR router. Similarly, traffic from the GCP will be logically received on this interface. The parallel processing capability eliminates the need for additional service blades inside the router, because all processing is performed on the FP.

Posted in Sex